Safety Recommendations - Zanotti GM Série Notice De Mode D'emploi Et D'entretien

Thank you for choosing Uniblock.
Please read these instructions carefully. They provide details and advice on the correct method of installing,
using and maintaining this unit, in order to obtain maximum reliability, efficiency and long life.

1 SAFETY RECOMMENDATIONS

When installing and using the unit please follow the recommendations listed here below.
• Installation shall be carried out in strict compliance with the diagrams and instructions supplied by the
manufacturer.
• Damages due to improper connections are excluded.
• The electric system available where the unit is installed shall meet the relevant standards in force.
• Maintenance shall be effected by trained personnel or by the manufacturer according to the provisions
supplied by EN378.
WARNING
Use safety gloves to protect your hands from possible cuts.
The user is strongly recommended to contact the manufacturer before attempting any intervention
on the unit and any use not corresponding to the manufacturer's indications (in particular as for the field of
application) and to enquire about the possible dangers and contra-indications connected with an improper use
of the machine.
• The unit shall be used following these instructions and sticking to the destination of use indicated by the
supplier. Any incorrect use can result in damages to the unit and represents a serious danger for people's
health.
ATTENTION
The unit is not suitable for working in explosive environments.
Therefore the use of the unit in an explosion-dangerous atmosphere is absolutely
forbidden.
ATTENTION
The unit is not suitable for working in salty environments. In such a case protect
condenser and evaporator with appropriate means.
When maintenance involves operations on the refrigerating circuit, empty the system and let it reach the
atmospheric pressure.
WARNING
Do not discharge the refrigerant in the atmosphere. It must be recovered by
specialized technicians using suitable equipment.
• Quantity and quality of the refrigerant to be charged are indicated on the data plate.
• Do not use refrigerants of different kind (especially inflammable fluids, for example hydrocarbons) or air.
• Do not modify or alter the refrigerating circuit or its components (for example: welding on compressor
body)
• The final user shall protect the system from external fire dangers.
19