User Manual; Important - IBCONNECT INTRO 2.0 Manuel D'installation

User Manual

01
+1,4
66
-0,0
02
03
1
2
04
+1,5
-0,0
max.31mm
min. 5 mm
espesores
INSTALLATION ON TABLE
Make the cut at the table respecting the
tolerances shown in pic.1
The Intro2.0 profile can be installed on tables
with thicknesses from 5 mm to 31 mm.
Removethe trim tabs by pullingout for accessing
to the fastening pieces.
Insertfirstlythe power cable and then introducing
the profile as shown in pic.3. with a Torx
screwdriver
tip and turning in clockwise till the profile is
properly fastened on the table.
IMPORTANT: If the operation is performed with
an electric screwdriver, you must regulate the
force to avoid damaging the fastening system.
Once we have fixed the product onto the table,
we mount the trim flaps as shown in pic 04.
EN