Wellcare WE-167CSHD Mode D'emploi page 13

Due to the temperature variation in different
environments (room, bed, etc.), an orange light
may be lit on APS display to indicate continuous
heating during the heating cushion is in use. That
said, the 3-color LED may change from green
to orange to heat up. Under this circumstance,
please note the product is functioning properly
when the orange light is indicated.
Red light and Beep Sound – Possible
•
malfunction or overheating, stop immediately.
The red light and beep sound give warning for the
below situations :
When the power is on but detachable plug-in
•
connector(6) is not connected : There will be
beep sound every second. Please connect the
detachable plug-in connector(6) to the
connection box(7) and switch on the controller
again.
When the critical components are damaged :
•
There will be continuous beep sound. Please
disconnect the mains cable from wall outlet
immediately.
When the heating wires or other components
•
are broken and the device cannot work
anymore : there will be beep sound every
second.
When the heating cushion (8) is folded or
•
covered completely, the device will reach
higher temperature : there will be beep sound
every 2 seconds. Please switch it off and check
if incorrect using.
EN
13