Using The Remote Control - Livington Handy Heater Deluxe Mode D'emploi

OPERATING INSTRUCTIONS:
1.
2.
3.
4.
5.
NOTE: STAND-BY MODE
Press the on/off power switch on the remote control in order to activate the stand-by mode. During this
mode, the digital display on the appliance is deactivated and emits no heat. Press the on/off power switch
again on the remote control to reactivate the appliance. In some cases the heating elements are illuminated
in a light orange. This does not represent any defect and does not consume any power.

USING THE REMOTE CONTROL

A battery is already inserted in the supplied remote control. Please remove the plastic film from the battery
compartment in order to activate the battery.
Insert a new battery in the remote control or replace the battery:
1. 2.
For optimal signal transmission, ensure that there are no obstacles between the appliance and
the remote control. The range of the remote control is approximately 3 metres.
M13461_M13462_Manual_HandyHeater_370W_Deluxe_20170825_DR.indd 13
Plug the Livington Handy Heater Deluxe into desired power outlet.
Press „On/Off Switch" on side of the unit to „On" position to turn on the heater.
Use the „+" button on the appliance or the remote control to increase the
temperature, or the „-„ button to lower the temperature, within a range of
15 °-32 °C on the „Digital Display".
Select your desired fan speed from the fan blower. Press the „Speed" button on
the appliance or the remote control to choose between High(HH) or Low(LL) on
the display.
After use, set the 'On-Off' Switch to 'OFF'. Let the Livington Handy Heater Deluxe
cool down. Only after that, remove the connection plug from the supply. Store the
appliance cool and dry until the next time of use.
1. Pull out the battery compartment on the underside of
3.
2. Insert a battery (Type CR2032) with the + polarity
3. Slide the battery compartment back again, as
the remote control.
upwards in the battery compartment.
illustrated on the back of the remote control.
13
25.08.17 11:50