Trouble Shooting; Repairs - Probst Pc-200 Instructions D'emploi

Maintenance and care
6.2

Trouble shooting

INTERRUPTION
The clamping force is not
sufficient, the load slips off
(optional)
(optional)
Material properties
The device hangs askew
Gripping range setting
(optional)
6.3

Repairs

Only persons with the appropriate knowledge and ability are allowed to repair the device.
Before the device is used again, it has to be checked by a qualified person or an expert.
53100444
CAUSE
The gripper jaws are worn
Load capacity is greater than permitted Reduce load capacity
The material surface is dirty or the
building material is not
suitable/permissible for this device
The pliers are loaded on one side
Suspension hole incorrectly selected
16 / 18
REMEDY
Replace gripper jaws
Check the material surface or consult
the manufacturer as to whether the
material is permissible for this device
Distribute load symmetrically
Use a different suspension hole
GB