Garmin Force Kraken Manuel De Demarrage Rapide page 3

2 Thread the other end of the lanyard
3 If necessary, place the lanyard around your neck or wrist to tether it during
use.
Deploying the Motor from the Stowed Position
1 Hold down the pedal to release the latch
2 Slide the motor out and release the pedal, and then lower the motor
slowly into the deployed position.
3 If necessary, push the shaft away to lock the motor in the deployed position.
Quick Start Manual
through the loop, and pull it tight.
.
Adjusting the Depth of the Trolling Motor
1 Stow the motor.
2 Loosen the collar on the motor shaft.
3 Slide the collar to raise or lower the depth of the trolling motor.
NOTICE
Do not set the motor depth so low that it compresses the coiled cable. When
the coiled cable is compressed, it will be damaged by friction as the motor
steers, and may cause unexpected movement when using the anchor lock
feature.
4 Tighten the collar.
5 Deploy the motor to check the depth.
6 Repeat this procedure if necessary to set the correct depth.
Stowing the Motor from the Deployed Position
NOTICE
You must allow the drive motor to stop rotating completely to one side before
moving it to the stowed position. If the motor is still rotating to one side when
you move it to the stowed position, it may damage the steering system.
1 Hold down the pedal to release the latch .
3