x-sense XS01-WX Manuel D'utilisation page 4

Add a Smoke Alarm
Before adding a smoke alarm, make sure you have a stable 2.4 GHz
Wi-Fi network and enable Bluetooth services on your phone.
1. Tap "+" in the right top corner of the app homepage, select "Smoke
Alarms", then select "Wi-Fi Smoke Alarms" and tap "Next" to add a
device.
2. Remove the insulating film to power up the smoke alarm.
3. Enter a name for the smoke alarm. Select the home you created or
create a new home for the smoke alarm, then select the room in
which it is installed. If you create a new home, you will need to enter a
name and select the country or region in which you live.
4. Press and hold the Test/Silence button on the smoke alarm for five
seconds until it flashes blue. Immediately tap Operation Confirmed
before the light goes off; or else you need to repeat the step to make
the LED indicator flash blue.
Note: If your mobile phone finds two or more devices waiting to connect
to the network, you need to tap to select the corresponding device you
want to add.
04
5. Connect to a 2.4 GHz Wi-Fi network and make sure you enter the correct
password. Then, the smoke alarm will enter the pairing process. Make sure
the Test/Silence button (the LED indicator) is still flashing blue; or else you
need to press it to make it flash blue again.
6. When finished, you will see the smoke alarm on the app's device list.
Note:
If your router supports a dual band network with both 2.4 GHz and 5 GHz,
please create separate SSIDs for the 2.4 GHz and 5 GHz channels.
This device is only compatible with a 2.4 GHz Wi-Fi network.
To promote successful Wi-Fi connection, make sure you place the
alarm within the router range, and that you enter the correct password.
05