gomag GO-BC 4.5 Twin Traduction Du Mode D'emploi Original page 22

ATTENTION
– If the red LED flashes, the battery has overheated and cannot be charged.
– If the red and green LEDs flash together, the battery is defective.
4. Pull the battery* out of the battery mount (1).
5. Wait at least 15 min until a new charging process. Therefore, pull the mains plug out of the
outlet.
9 Electrical connection
The electrical motor installed is connected and ready for operation. The connection com-
plies with the applicable VDE and DIN provisions. The customer's mains connection as
well as the extension cable used must also comply with these regulations.
9.1 Important information
If the battery overheats, the charging process is terminated and the battery charger is switched
off. After the battery has cooled down, the charging process can be resumed.
Connection type Y
If it is necessary to replace the mains connection cable, this must be done by the manufacturer
or their representative to avoid safety hazards.
10 Cleaning
WARNING
Unplug the plug from the socket before carrying out any work on the battery charger.
• Clean the product with a dry cloth or brush.
• Do not use water or metallic objects.
11 Maintenance
The product is maintenance-free.
12 Storage
1. Remove the battery from the product before prolonged storage (e.g. winter storage).
2. Clean and check the product for damage.
3. Store the battery in a partially charged state.
4. When stored, check the battery charge level every three months.
5. Recharge the battery if necessary.
Store the battery in a dark, dry and frost-free place that is inaccessible to children.
22 | GB www.scheppach.com