Urmet 1092/252H Manuel D'utilisation page 11

Important!
Don't use the screw placed on the other side of the camera
5. Connect the video output to the selected terminal device.
6. Connect the terminals (+/-) of the RS-485 connector to a control keyboard (e. g. 1092/621) for camera
control and programming (all the parameters can be managed by a keyboard). Terminate the last
device of the line with a 120 ohm resistor. In case of long and/or underground cables, protect the
device with a dedicated filtering device (e.g. Urmet Ref, 1092/732).
7. Power the camera.
Unscrew the screw on the bottom of the camera to access to the adjustment screws and to the OSD
menu button.
8. Perform Zoom and Focus adjustment for the desired image as follows
Button for Focus and Zoom adjustment and
activation of the OSD menu
DS 1092-223
ADJUSTING SCREW
Unscrew to access to the
settings
11