Section 3 - Operation; Front Panel Controls For Invision 456P; Mode And Voltage Control For Invision 456P - Miller Invision 456P Mode D'emploi

3-1. Front Panel Controls For Invision 456P

1 Power Switch
The fan motor is thermostatically con-
trolled and only runs when cooling is
needed.
1

3-2. Mode and Voltage Control For Invision 456P

SECTION 3 – OPERATION
2 Voltmeter (see Section 3-3)
3 Ammeter (see Section 3-3)
4 Voltage Adjustment Control
5
1
5 Inductance Control
Inductance determines the "wetness" of the
weld puddle. When set higher, "wetness"
(puddle fluidity) increases.
2 3
1 Remote 14 Receptacle
Mode Control
The unit defaults to standard MIG
mode. When a suitable external
pulsing control is attached to the
Remote 14 receptacle, the remote
pendant controls whether the unit
is in standard MIG or pulsed MIG
mode. When the pulsing control is
disconnected, the unit returns to
standard MIG operation.
Voltage Control
The unit defaults to Panel control of
output voltage. When a suitable re-
mote voltage control or pulsing
control is attached to the Remote
14 receptacle, the remote device
assumes control of output voltage.
To return to Panel control of volt-
age, disconnect or disable any re-
mote devices that send an input to
pin E.
4
ST-180 306-C
ST-801 192
OM-186 989 Page 15