7. COMPLETING THE INSTALLATION
7.3. Mounting the handles on
cladded models
Note
To mount the handles onto the door
and the drawer operate as follows:
Operate as follows:
>
Insert the handle ends onto the supports
already installed on the door and the drawer
[ 1 ].
1
>
Screw in the set screws available on the handle [ 2 ].
2
The screws must be tightened in by means of
a 2.5 mm (1/8") hex key or driver.
7.4. Post installation checklist
Check that the front levelling feet have been
properly installed.
Check that the connection to the water
system does not have any leaks and that the
shut-off valve is easily accessible.
Check that the electrical connection is
correctly installed and that the socket and / or
breaker are easily accessible.
34
Check the perfect alignment of the appliance
with adjacent structures.
Check that all adhesive tape and external or
internal temporary protective devices have been
removed.
Check the perfect closing of the doors and
the smooth sliding of the drawers and shelves.
7.5. Start up
Serigra a B02919200
>To turn on all the appliance compartments,
press the Unit
display will show the message "Initial test" for
approximately 2 minutes. After this phase the
compressors will start up and remain on until the
compartment set temperatures are achieved.
>
If the appliance is provided with an Ice
Maker, prior to switching it on make sure that
the water filter cartridge is installed (unless
water supply source is already filtered by other
means such as reverse osmosis).
>
Purge air from the water lines by performing
the 'Manual Clean' function from the Menu-
Testo e gra ca
>Functions->Water Filter options. You may
need to complete this sequence several times
until you stop hearing air sputtering from the
ice maker fill tube (Refer to your Use & Care
Manual).
>
Once you are satisfied that the system is
purged of air switch the Ice Maker on in the
ice maker menu item
functions.
Manual for more details.
>
For further information about the appliance
operation, refer to the User Manual.
Limite per gra ca parti retro-illuminate - la parte bian
www.smeg.com
VETRO USER 599 LCD
button for three seconds. The
00
+
00
+
00
-
of the appliance
ICE
WATER FILTER
MAKER
Please refer to the Use & Care
CIRCUIT CLEANING
Funzioni
°C
°C
Impostazioni
°C