Panels Mounting; Overlay Door Panel Layout - Smeg Rbmu36R Guide D'installation

5. PANELS MOUNTING

5.1. Overlay door panel layout

The dimensions of the panels are indicated in
the table and drawings on subsequent pages.
Nevertheless, according to the requirements
for aligning with other kitchen structures, the
door panel can be higher than the upper edge
of the refrigerator door.
The panels must be mounted using special
brackets which attach to adjustable devices
provided on the door and drawer and with
brackets that anchor and adjust the panel's
vertical direction.
Brackets and fixing screws are provided with
the appliance and must be applied to the
panel as indicated.
For shaker or framed panel styles, it
may not be possible to affix the upper
or lower leveling brackets.
Operate as follows:
To prepare the panels to be mounted on the
appliance, follow these steps, working on the
back of the panel.
Door Panel
> Draw a vertical center line on the panel from
top to bottom [ 1 ].
1
> Starting from the bottom edge of the panel,
mark the positioning of the brackets [ 2 ].
2
> Following the corresponding table, mark the
external and then the internal hole [ 3 ].
3
> Position the brackets on each set of marks to
make sure they are aligned [ 4 ], if you choose
to drill small pilot holes for the screws pay spe-
cial attention to not pass through the panel
entirely. [ 5 ].
4
> Screw the brackets in place [ 6 ].
www.smeg.com
EN
5
6
17