What Do I Do In The Event Of An Error - delany BEAUTY HB-790 Mode D'emploi

separate strands of hair and insert them all the way into
the hair chamber! No hair may loosely hang over the
hair chamber (see Quick Start Guide).
9. Briefl y push the rotation trigger (3) to automatically draw in
the hair strand.
You can cancel the draw-in process at any time
by holding the rotation trigger (3) down (approx
1 second). As soon as the draw-in process is
interrupted, a signal will sound and the device will
rotate back by half of a turn so that you can remove
your hair easier.
10. When the set heating time starts to countdown, a signal will
sound at the beginning. Once the time has elapsed, three
more signals will sound to indicate that the set time is up.
You can now slowly pull the hair strand out.
11. Repeat the process with other strands until you have the
desired number of curls/waves.

What do I do in the event of an error?

If you have put too much hair in the device (e.g. hair strands
that are thicker than 2 cm or hair that is longer than up to the top
part of your back), the display shows the error message ER2
and the device may automatically deactivate!
ATTENTION!
• Do not panic or jerk the device to remove your hair from the
hair chamber!
• Do not forcefully pull on the hair strands as the device will
grip more tightly!
1. Keep calm!
31 EN