Geemarc CL7100 Mode D'emploi page 8

INSTALLATION
(1) Connect the power supply as shown in the diagram
(2) The transmitter/charger must be connected to the audio
OUTPUT sockets of the TV, audio equipment, cable or
satellite box, DVD or VCR player, etc. When an RCA type
cable is used the outputs jacks are red and white. Refer to
the diagram
A Scart adapter(not included) may also be used. Use only
the red and white terminals.
NOTE: If the system is connected to a cable or satellite box
and to a DVD or VCR player it is necessary to turn off the
device which is not in use at the time. When using the DVD
or VCR player turn off the cable or satellite box. When
watching TV turn off the DVD and VCR player.
(3) Connecting to a digital converter box(DAC)
Connect the digital audio output from the TV or audio device
to the DAC using an appropriate cable (optical or coaxial
cable). Then use the supplied RCA type cable to connect
from the red and white output terminals of the DAC to the
audio input socket of the transmitter/charger.
NOTE: If you wish to use the system to listen to TV while
the CL7100 is muted so as not to disturb others, the TV
audio output must be set to FIXED. Refer to the user manual
of your TV for instructions as to how to set to FIXED.
POSITIONING
The infra-red(IR) signals need a direct line-of-sight
connection between the transmitter and the headset.
Position the transmitter such that there is a direct line-of-
sight connection with the headset when in use. The IR
signals may be blocked by objects such as walls, doors,
furniture, newspapers, books, etc. The IR diodes are lit
during use.
NOTE: When there is no audio input to the
transmitter/charge, transmission is turned off automatically
and the blue LED goes off. This is resumed automatically
when audio signal is restored.
7