Intended Use; Preparing Of The Blower Vac Prior To Use - Lea LE50280BV3 Mode D'emploi

•
Local regulations may restrict the age of the operator.
•
Before use, examine the cable for signs of damage, or ageing. Do not use the product if
the electric cables are damaged or worn.
•
Arrange the extension cord so that it cannot be damaged and does not cause a
hindrance.
•
If the cord is damaged during utilisation, it must be disconnected immediately from the
mains. DO NOT TOUCH THE CORD BEFORE IT IS DISCONNECTED FROM THE
MAINS.
•
Make sure to have a safe stand when working on inclines.
•
Move the tool at walking speed only.
•
Inspect the collection bag regularly. If the collection bag becomes worn or damaged,
replace.
4.7 Remove the plug from the mains supply
•
Before leaving the Vac-Blower unattended for period;
•
Before clearing any blockage;
•
Before checking, cleaning or carrying out any work.
•
If a foreign body, or other debris, is accidentally feed into the Vac-Blower, stop it
immediately and do not use the Vac-Blower until it has been checked and you are sure
that the entire Vac-Blower is in a safe operating condition.
•
If the Vac-Blower makes any unusual noise or starts to vibrate abnormally STOP
immediately remove the plug from the mains supply and investigate the cause.
Excessive vibration can cause damage to the Vac-Blower and injury to the operator.

5. INTENDED USE

The leaf vac is exclusively used in the two following ways:
1) As a leaf vac for vacuuming up dry leaves.
2) As a blower it is used to collect together dry leaves or to remove them from inaccessible
places (e.g. under vehicles).
In suction mode it also works as a shredder, where the volume of the leaves is reduced by a
ratio of approx. 10:1 and takes up less space in the leaf collection bag and the collected
material is simultaneously prepared for possible composting.
Each type of use other than those given in these instructions for use can damage the
machine and cause serious risk to the user.
Please always observe the safety instructions in order to safeguard your guarantee claim and
in the interests of product safety. Due to the machine's design, we are unable to fully exclude
all residual risks.
6. UNPACKING
Due to modern mass production techniques, it is unlikely that your power tool is faulty or that
a part is missing. If you find anything wrong, do not operate the tool until the parts have been
replaced or the fault has been rectified. Failure to do so could result in serious personal injury.

7. PREPARING OF THE BLOWER VAC PRIOR TO USE

18