Advanced Diagnostics Silca Smart Remote Programmer Mode D'emploi page 9

SMART Remote Programmer
POWER ON (F) (Fig.3)
This bu on works only if the device is powered by the ba eries; press bu on to power on, hold it for more
than 3 seconds to power off . If the device is powered from a PC using the USB cable the device is always on.
RESET G (Fig.3)
Use if the device is not responding to programming instruc ons.
LED
There are 2 leds on the device
RED led (D): (Fig.3)
- fi xed light: device is on;
- blinking light : device is receiving and transmi ng data
BLUE led (E): (Fig.3)
- fi xed light: device connected to mobile device via Bluetooth;
- blinking light: device is disconnected
USING THE SMART REMOTE PROGRAMMER
The SMART Remote Programmer can be connected in following ways:
- Via a USB to a PC using the appropriate so ware available on www.silca.biz - www.ilco.us
- Via Bluetooth 4.0 to Android or IOS mobile devices
Procedure for using the Smart Remote Programmer with a PC:
A er having installed the appropriate so ware on the PC switch on the Smart Remote Programmer connec-
ng it with the USB cable to a PC.
- On the PC open the Smart Remote Programmer so ware and check that the device is connected. If a
message says "drivers not installed" please install the drivers by opening the folder "drivers" in the Smart
Remote Programmer fi le. Restart the program.
- Select the search func ons by clicking the icon
- Select the car model needed to preset the remote
- Place the new Ilco/Silca remote on area "B" of the device
- Select "preset the remote icon"
- The device will preset the Ilco/Silca new remote ready for programming in the vehicle
Procedure for using Smart Remote Programmer with a Smartphone or Tablet:
- Switch on the Smart Remote Programmer by pressing bu on "F" (check that the ba eries are installed) and
the red LED "D" is lit.
- Switch on the bluetooth connec on on the smartphone or tablet
- A er star ng the App the user will be guided through the process to connect the Smart Remote Program-
mer
- Open the main menu by clicking icon at the top of the screen
- Select the Search func on
- Select the car model needed to preset the remote
- Place the new Ilco/Silca remote on area "B" of the device
- Select "programm bu on" on the screen and follow the instruc ons given
- The device will preset the Ilco/Silca new remote ready for programming in the vehicle
FEATURES
at the top of the screen
on the screen and follow the instruc ons given
Copyright Silca S.p.A 2017
English
7