Publicité
Les langues disponibles
Les langues disponibles
Advice on location, care and safety
•
Connect the audio input to the line-out, non amplified output. Avoid connection to the
speaker-out jack of your sound source. The amplified signal from the speaker-out may cause
unnecessary distortion and may damage the speaker-circuit.
•
To connect your sound-system with power supply system, please make sure to have a mains
socket close to your sound-system.
•
Before mains connections, check your mains power system to be appropriate to the
TWO
/
. The mains voltage (230V or 115V) of your power system you can set by the
NEO
PRO
VOLTAGE SELECTOR of your TWO
the actual setting of the mains voltage easily. Attention: if the mains voltage is set wrong, the
device may become defective! Always set the correct mains voltage to avoid defects!
•
If the sound-system is not in use for a longer period of time, be sure that your system is
disconnected from mains power.
•
Do not use alcohol, benzene, thinner or acids to clean the cabinet.
Do not place your sound-system near radiators, airconditioning or radio-controlled systems.
•
•
Avoid leaving the sound-system in permanent strain such as direct sunlight, extreme moist or
dryness, exceptional cold or heat, mechanical vibrations or shock.
•
Do not open the cabinet, contact qualified personnel only.
For service staff: Never open cabinet, when speaker system is connected to 110-240 V
•
AC power supply system.
•
CAUTION!! Power ON / STANDBY switch does not separate mains power!
Deliberate harm to the equipment is not covered by the guarantee.
•
•
Please contact your dealer in case of technical problems.
English
/
(beside the POWER switch) and you can verify
NEO
PRO
14
Publicité
