Troubleshooting - Skil DL181901 Guide D'utilisation

RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT
ALTERNATING CURRENT TOOLS
Tool's Ampere Rating
3-6
6-8
8-10
10-12
12-16
TROUBLE SHOOTING
Problem
Tool will not start
Tool does not come up to
speed
Excessive vibration
Accessory binds, stalls
motor or kicks back when
drilling
16
Cord Size in A.W.G
Cord length in feet
25 50
18 16
18 16
18 16
16 16
14 12
Cause
1. Power cord is not plugged in.
2. Power source fuse or circuit
breaker is tripped.
3. Cord is damaged.
4. Burned out switch.
1. Extension cord has insufficient
gauge or is too long.
2. Low house voltage.
1. Accessory being used is bent
or damaged.
2. Accessory being used is not
secure in chuck.
1. Damaged accessory.
2. Incorrect accessory for drill
speed.
Wire sizes in mm
100 150
16 14
14 12
14 12
14 12
- -
1. Plug tool into a power source.
2. Replace fuse or reset tripped
circuit breaker. (If the product
repeatedly causes the
circuit or fuse to trip/blow,
discontinue use immediately
and have it serviced by an
Authorized SKIL Service
Center or Service Station.)
3. Inspect cord for damage.
If damaged, have cord
replaced by an Authorized
SKIL Service Center or
Service Station.
4. Have switch replaced by an
Authorized SKIL Service
Center or Service Station.
1. Replace with adequate
extension cord (Refer to
the part of "EXTENSION
CORDS").
2. Contact your electric
company.
1. Discard and replace with new
accessory.
2. Reference the "Inserting Bit"
section of manual.
1. Discard and replace with new
accessory.
2. Use properly rated accessory
as indicated by accessory
manufacturer.
2
Cord length in meters
15 30 60
0.75 0.75 1.5
0.75 1.0 2.5
0.75 1.0 2.5
1.0 2.5 4.0
- - -
Remedy
120
2.5
4.0
4.0
-
-