Accessories - LENCO KCR-100 Guide D'utilisation

ACCESSORIES

• Mounting kit (plastic plate + 2 sets of screws + 4 spacers + drill hole paper template)
Plastic plate
• Instruction manual
MOUNTING THE SET UNDER A CABINET
1. Decide the location to install the unit in the cabinet/shelf. Since the unit's speakers are located on the left edge side and right
edge side respectively, it is recommended to reserve enough space to avoid blocking the sound.
2. Once the location is decided, you can use the drill hole paper template (supplied) as a guide hole location to drill the holes.
3. Install the plastic plate under the cabinet/shelf using the supplied spacers and screws, refer to the diagram below. Spacers are
optional to install as your preference. 2 sets of screws are provided for your selection. The longer screw set is usually used when
the spaces are used. Depends on the wooden board thickness, you may decide to use other suitable screw length by yourselves.
4. After the plastic plate is installed, slide the unit into it until it locks securely.
5. Due to its weight, the unit should be installed with great care. Make sure that the cabinet that is used is sturdy enough to
support the weight of the unit.
Note:
- To reduce the risk of fire, do not place the radio on any heating area or without the spacing.
- You can slide out the unit from the plastic plate and to be used as a standing kitchen radio.
Spacer Drill hole paper template
5