Wagan Pivot Stepper 9732 Guide D'utilisation page 7

9. After the assembly is complete, check the position of the sensor at the
Base. During set up, the sensor may have been pulled too far in as the
Power Cable was threaded upward through the tubes (shown above in
the first photo marked with an ). Gently pull the sensor out to adjust
the location as shown in the photo above marked with a check mark
(). Make sure you do not pull the sensor all the way out either (as
shown in the third photo which is also marked with an ), causing the
cable to disconnect from the LCD Meter.
MAINTENANCE
• Inspect the Pivot Stepper at regular intervals to check to see whether
there are loose joints and/or parts that have been damaged or worn.
• Store the Pivot Stepper in a cool and dry environment.
• Don't clean the surface of the Pivot Stepper with organic solvents (i.e.
gasoline, benzene, etc.) or its surfaces may become damaged.
• Inspect the unit thoroughly before beginning exercise on it. Make sure
that there are no issues with the equipment such as loose joints, loose
hydraulic parts, or wobbling pedals.
• This product is designed only for use by individuals with a weight not
exceeding 220 lbs.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2016 Wagan Corporation. All Rights Reserved.
6