Wolf ICBSPO24TE/S Guide D'utilisation Et D'entretien page 14

Care Recommendations
Care Recommendations
CLEANING
Stainless Steel Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural luster,
lightly wipe the surface with a water-dampened microfiber cloth followed by a dry polishing chamois.
Always follow the grain of stainless steel.
Door Front
Spray glass cleaner on a cloth to clean.
Control Panel Use a spray degreaser to remove fingerprints and food soil. Spray on a cloth before wiping the control panel.
IMPORTANT NOTE: Do not spray cleaners directly on the control panel.
To lock the control panel before cleaning, refer to page 8.
Interior Wipe with a soft damp cloth. Do not use abrasive or harsh cleaners or scouring pads. For heavier soil, use
baking soda or a mild soap; rinse thoroughly with hot water. Do not use chemical oven cleaners.
Oven Racks and Risers Remove for cleaning. Wash in water with mild soap. For stubborn stains, use a mild cleanser and non-abra-
sive scouring sponge. The racks and risers are dishwasher-safe.
Turntable Remove for cleaning. Wash in water with mild soap. For stubborn stains, use a mild cleanser and non-abra-
sive scouring sponge. The turntable is dishwasher-safe.
Waveguide Cover Located on the inside top of the microwave interior. Carefully wipe with a soft damp cloth. Do not remove
the waveguide cover.
14 | English
Troubleshooting
Troubleshooting
Oven does not operate.
• Verify power is on.
•
Verify electrical power to the oven and home circuit
breaker is on.
Food in the oven is not heating.
• Check the controls to verify the proper setting.
•
The oven is in Demonstration mode. Refer to page 9
to cancel.
Time on the display counts down very rapidly.
• The oven is in Demonstration mode. Refer to page 9
to cancel.
The interior light does not work.
• Contact Wolf Factory Certified Service.
The touch controls will not operate.
• The control panel lock is on. Refer to page 8 to unlock.
The display flashes.
• Power outage. Touch and reset the clock. If the
oven was in use, reset the cooking function.
Radio or TV interference caused by the oven.
• Verify the oven is on a different electrical circuit, relo-
cate the radio or TV as far away from the oven as pos-
sible, or check the position and signal of the antenna.
SERVICE
• Maintain the quality built into your product by contact-
ing Wolf Factory Certified Service.
• When contacting service, you will need the model and
serial number of your product. Both numbers are listed
on the product rating plate. Refer to page 8 for rating
plate location.
• For warranty purposes, you will also need the date of
installation and name of your authorized Wolf dealer.
This information should be recorded on page 2.
SERVICE (FOR AUSTRALIA ONLY)
• Yearly maintenance is recommended.
• Maintain the quality built into your product by contact-
ing Wolf Factory Certified Service.
• When contacting service, you will need the model and
serial number of your product. Both numbers are listed
on the product rating plate. Refer to page 8 for rating
plate location.
• For warranty purposes, you will also need the date of
installation and name of your authorized Wolf dealer.
This information should be recorded on page 2.
• For Australia only, contact:
Sub-Zero Group Australia Pty Ltd
Level 10, 469 La Trobe Street
Melbourne Victoria 3000
Phone 03 9600 2218
subzero-wolf.com.au
SERVICE (FOR UNITED KINGDOM ONLY)
• Sub-Zero & Wolf Ltd
9 The Street, Heybridge, Maldon, Essex, CM9 4XB
020 8418 3800
service@subzero-wolf.co.uk
www.subzero-wolf.co.uk