5 Setting The Transmission Frequencies; For The Four Receiver Sections; 5 1 Setting The Frequency Manually - Monacor JTS R-4/5 Mode D'emploi

2) The brightness of the level indicators RF
(10) and AF (11) can be set via the menu item
:
2.Indicator
Indicator
5
3) The antenna inputs (16) are factory-set to sup-
ply a 12 V operating voltage for antenna
amplifiers (e g UB-900I) If no antenna am-
plifier is used, deactivate the 12 V operating
voltage via the menu item
:
Power
Antenna Power
ON
OFF
4) Via the menu item
, the output level for the mixed sig-
Level
nal of the microphones at the connections
MIXED AF OUTPUT (18) can be set to line level
or microphone level:
Mixed Output Level
Line
Mic.
for connection to a line level input
Line
for connection to a microphone input
Mic
5) For a reset to the factory settings, select the
menu item
5.Reset
warning the user that resetting will erase any
data stored:
This will erase all data
from receiver's Internal
Storage
Press S 2 Sec to Reset
To exit, press the button EXIT; to reset, keep
the button SETUP pressed for 2 seconds until
appears
Erasing ...
Fig. 7
3.Antenna
Fig. 8
4.Mixed Output
Fig. 9
A message appears
Fig. 10

4.5 Setting the transmission frequencies

for the four receiver sections

Make sure that the corresponding transmitters
(wireless microphones/pocket transmitters) are
switched off and then set the receiver to an in-
terference-free transmission frequency There are
different methods to do this:
1 The transmission frequency can be adjusted
manually between 506 000 MHz and 542 000
MHz (chapter 4 5 1)
2 For operating multiple transmitters at the same
time (chapter 4 5 2), there are 6 groups with
up to 22 channels in each group (see overview
on page 27) In ideal conditions, all channels
of a group can be used for audio transmissions
at the same time
The scan function can be used to deter-
mine the channels being used for transmission
by other systems (chapter 4 5 3) These chan-
nels will be skipped during channel selection
3 Preferred frequencies can also be saved to six
user-defined frequency groups (chapter 4 5 4),
e g for operation in varying locations
4.5.1 Setting the frequency manually
1) The setting menu for the receiver section can
be called up in two ways:
1 Press the button SEL (12) of the receiver sec-
tion desired (on the display, the field of the
receiver section is highlighted); then keep
the button SETUP (6) pressed until the menu
(fig 11) is shown
2 Keep the button SETUP pressed until the
menu with the line
is shown Use the button PUSH / CON-
TROL (7) to select the receiver section
CH1 – CH4 and then press the button to
call up the setting menu
FREQ. G-CH ID
1 507.500 1-1 1
2 ? 508.500 1-2 2
3 512.000 1-3 3 -10
×
4 514.125 1-4 4 -10
×
Fig. 11 Setting menu: The menu items are shown
on the right; the settings of the receiver sections are
shown on the left (see following page for explanation)
1.System Options
1.Frequency
0
2.Group/Channel
-2
3.Scan
4.Squelch
21