Final Check - LG LDF554 Série Manuel Du Propriétaire

Final Check

1
Turn on electrical power.
2
Turn on house water supply.
3
Make sure the door opens and closes smoothly.
If necessary, level the dishwasher again.
If the door will not close, make sure the rack
is level and all packaging materials have been
removed.
4
Run the dishwasher on a Turbo cycle to verify
proper operation and check for leaks.
CAUTION
• Only install the lower cover provided with the
machine. Do not install cabinet baseboard as it
may cause noise and leakage.
Cabinet baseboard
Lower cover
Error Code Possible Cause and Solution
Drain hose kinked or pinched.
Feed the drainage and supply
hoses through the hole under
the sink. Then gradually slide the
dishwasher into the cabinet while
pulling on the hoses under the sink
to take up any slack. This helps
avoid kinking the hoses or trapping
OE Error
them beneath the dishwasher.
Drain hose connected to
disposal.
Remove knockout plug on disposal.
Waste tee is clogged.
Remove knockout plug on waste
tee.
Water supply line kinked under
dishwasher.
Feed the drainage and supply
hoses through the hole under
the sink. Then gradually slide the
dishwasher into the cabinet while
pulling on the hoses under the sink
IE Error
to take up any slack. This helps
avoid kinking the hoses or trapping
them beneath the dishwasher.
House water supply not turned
on.
Turn water on.
INSTALLATION 21