Adjust Shelves; Adjust Doors; Install Hooks - Whirlpool Gladiator GRANDE ARMOIRE À OUTILS ET CAISSE À OUTILS EN ACIER SOUDÉ Instructions D'assemblage

11. Holding the casters in place, tighten the self-locking nuts with a
⁷⁄₁₆" socket wrench.
A. Front of cabinet
B. Rigid casters
IMPORTANT: Block the back casters to keep the cabinet/locker from
rolling when moving it to an upright position.
12. Return the cabinet to its upright position, and unlock the door.

Adjust Shelves

Remove the Shelves
1. Remove the shelf clips from their shipping position on the sides
of the cabinet. Working from the inside of the cabinet and using a
blunt tool, push out the plastic shelf clips. Discard the clips.
2. Lift up on the underside of the shelf until the shelf tabs are free of
the cabinet slots.
3. Tilt the shelf up to reposition it within the cabinet or to remove it
from the cabinet.
Replace the Shelves
NOTE: Plan your shelf heights and install shelves starting from the
bottom. The shelves are supported by the metal tabs on the back
and side walls of the cabinet.
1. Determine the placement of the shelves.
2. Tilt the shelf so that one end is higher than the other as shown.
B
A. Push down
B. Lift up
4
A
B
C
D
C. Caster brakes
D. Swivel casters
A
3. Insert the shelf into the cabinet so that the higher end is directly
above the desired slots and push the shelf down in place behind
the side slots.
4. Raise the lower end so it is directly above the desired slots and
push the shelf down.
NOTE: Make sure the shelf tabs are in place behind all the slots,
as shown.
5. Repeat this process for the remaining shelves.

Adjust Doors

The cabinets are designed with adjustable doors.
1. Place the cabinet/locker in the desired location.
2. Check to see whether the doors need adjusting. It is more often
the left door that will need to be aligned.
3. Using a Phillips screwdriver, loosen all screws attaching the
hinge to the cabinet.
4. Adjust door to the desired height.
5. Tighten the screws.

Install Hooks

(locker model only)
1. Unlock and open the locker doors.
2. Insert the four pan-head screws through the four holes in the top
of the locker.
3. Tape the screws to the exterior locker top to hold them in place.
4. Slide the double hook over two screws and attach with the
#10 - 24 nuts.
5. Repeat Step 4 to attach the other double hook.
6. Tighten all four nuts with a ³⁄₈" wrench while holding the heads of
the screws tightly against the locker top.
A
B
A. Slot
B. Shelf tab