Makita DGP180 Manuel D'instruction page 13

4. Install B-type barrel.
2
1
5
3
► 1. Joint 2. Rubber packing 3. Tab 4. Groove
5. Screw
Changing the barrel from B-type to
A-type
1. Remove B-type barrel.
2. Unscrew and remove the joint.
2
► 1. Joint 2. Rubber packing 3. Screw
3. Insert the sleeve into the tool housing, then secure
it with a screw.
4. Install A-type barrel.
1
► 1. Sleeve 2. Screw
4
1
3
2
Cartridge barrel
You can see the grease cartridge through the hole on
the cartridge barrel.
When using the cartridge barrel, transfer the piston
parts from the corresponding barrel to the cartridge
barrel.
► 1. Piston parts 2. Cartridge barrel
If it is hard to pull out the rod handle, follow the proce-
dure below.
1. Insert the empty grease cartridge into the barrel.
► 1. Empty grease cartridge
13 ENGLISH
1
2
1