Functional Description - Makita AN611 Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
• Always lock the trigger and disconnect the hose
before adjusting or checking function on the tool.
Adjusting depth of nailing
To adjust the depth of nailing, turn the adjuster so that
the arrow above the adjuster will point to the number indi-
cated on the adjuster. The depth of nailing is the deepest
when the arrow points to the number 1. It will become
shallower as the arrow points to higher number. The
depth can be changed in approx. 1.0 mm (1/32") incre-
ments per graduation. If nails cannot be driven deep
enough even when the arrow points to the number 1,
increase the air pressure. If nails are driven too deep
even when the arrow points to the number 9, decrease
the air pressure. Generally speaking, the tool service life
will be longer when the tool is used with lower air pres-
sure and the adjuster set to a lower number.
ASSEMBLY
CAUTION:
• Always lock the trigger and disconnect the hose
before carrying out any work on the tool.
Loading nailer
1
2
Select nails suitable for your work. Depress the latch
lever and open the door and magazine cap.
Lift and turn the coil support plate to set it to the correct
step. When loading 57 (2-1/4") or 65 mm (2-1/2") long
nails, use the bottom step. When loading 45 (1-3/4") or
50 mm (2") long nails, use the middle step. When loading
32 (1-1/4") or 38 mm (1-1/2") long nails, use the top step.
If the tool is operated with the coil support plate set to the
wrong step, poor nail feed or malfunction of the tool may
result.
005240
1. Adjuster
1
005241
1. Door
2. Latch lever
3. Magazine cap
3
Place the nail coil over the coil support plate. Uncoil
enough nails to reach the feed claw. Place the first nail in
the driver channel and the second nail in the feed claw.
The nail heads must be in the slot in the feeder body.
Place other uncoiled nails on feeder body. Close the
magazine cap and door after checking to see that the nail
coil is set properly in the magazine.
Connecting air hose
1
Lock the trigger. Slip the air socket of the air hose onto
the air fitting on the nailer. Be sure that the air socket
locks firmly into position when installed onto the air fit-
ting. A hose coupling must be installed on or near the tool
in such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
OPERATION
CAUTION:
• Make sure all safety systems are in working order
before operation.
5
005242
1. Coil support
plate
1
005243
1. Slot
1
2. Feeder body
2
005244
1. Air fitting
2. Air socket
2