Electrical Power Supply - Essilor CP550EA Manuel D'utilisation

10. Installation
10.1. Projector installation
Fasten the projector connector to the ball joint on the stand as indicated, then tighten the side screw (12) using the
hex head key. If the connector has not been appropriately fastened, the projector could suddenly swivel and cause
injury.
10.2.

Electrical power supply

Connect the power supply cable to the electrical socket (8) and then to the wall outlet (AC).
10.3. Remote control
Remove the cap from the battery compartment of the remote control unit. Load two SUM4 batteries in respecting the
+ and - markings.
10.4. Screen set-up
Insert the cable supplied with the device into the two ports located on top of the screen, then tie the two ends.
Fasten a hook into the wall at the height of the patient's point of observation, then hang the screen horizontally.
The presentation distance must lie between 2 and 7 meters.
If you are not using the standard screen included with the projector, you will not be able to obtain the same
performance as with the original diagnostic equipment.
The projection must be made on the smooth and shiny side.
10.5. Projection focusing
6- The projector and patient must be positioned the same distance from the screen.
When changing projection distance, the size of the vision test types (or optotypes) automatically varies to
ensure constant compliance with optotype presentation standards.
ESSILOR UMCP550 V1 OCT2015
14)
13)
18)
17)
13) LAMP: Lamp activation
15)
14) ROOM: Room light activation
15) PROGRAM: Program (1,2)
16) Tests
17) Masks
16)
18) Red-green filter
20) 19) Program scrolling
19)
20) Confirmation button
16
BACK
NEXT