Health O Meter Professional 524KL Mode D'emploi page 4

Remove 4 screws from bottom of Lower Pillar (B)
1. Locate and pull down cable inside (A) and plug cable into the base (B).
2. Connect Upper Pillar (A) to Base (B). Secure Pillar to Base using 4 screws provided.
3. Mount brackets (C )& (D) using screws provided. Note bracket (C) is the short bracket
and must be placed where shown in the diagram.
4. Attach seat to brackets and secure by tightening the black knobs.
C
A
WATCH OUT FOR PINCH POINTS
DURING ASSEMBLY THAT MAY
DAMAGE INTERNAL CABLE!
D
B
4
CAUTION: