AEG X79464MI1 Manuel D'utilisation page 5

5. CONTROLS
The hood is fitted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
The control switches are located on the
unit's front panel:
1 2 3
1 Motor key OFF (stand by) – Excludes
the electronics
MOTOR OFF
Press briefly to switch the motor off.
EXCLUDING THE ELECTRONICS
Press the key for 3 seconds. The hood
command electronics will be excluded.
This function can be useful during
the product cleaning operations. Just
repeat the operation to reinsert the
electronics.
Attention! when using the appliance
for the first time, insert the electronic
control unit that results excluded by
default
2 Low-speed selection key (suction
power)
3 Medium-speed selection key (suction
power) power);
4 High-speed selection key (suction
power);
press again to activate the intensive
timed function - duration 5 minutes
(the hood will automatically go back to
the medium extraction power)
5 RESET FILTERS SIGNALS
- ON function:
press the key while the hood is
switched off; the symbol lights up for 3
seconds to confirm the activation;
4 5 6
F
- OFF function:
press the key while the hood is
switched on; the symbol flashes for 3
seconds to confirm the disabling;
After 40 hours of use, the symbol lights
up, indicating that the grease filter
needs washing;
After 160 hours of use, the symbol
flashes, indicating that the carbon filter
needs replacing.
In both cases the indication lasts 60
seconds after the hood has been
switched off; to reset the indicator and
restart the count, press the key while
the hood is switched off.
6 Light key ON/OFF
Attention! If the hood fails to operate
correctly, briefly disconnect it from the
mains power supply for almost 5 sec. by
pulling out the plug. Then plug it in again
and try once more before contacting the
Technical Assistance Service.
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the
LED light.
To replace lights, contact authorised spare
part center.
ENGLISH 5