Publicité
Les langues disponibles
Les langues disponibles
If the appliance is
overloaded, remove
some items from the
drum and/or keep
pressed the door and
push the Start/Pauze -
Départ/Pause button at
the same time until the
indicator
flashing (see the picture
below).
13.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
stops
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse
box.
• Make sure that the Start/Pause has been pressed.
• If the delay start is set, cancel the setting or wait for the
end of countdown.
• Deactivate the Child Lock function if it is on.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to "Care and cleaning".
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the connection of the water inlet hose is
correct.
• Make sure that the connections of the water inlet hoses
are correct.
•
- The mains supply is unstable.
Wait until the mains supply is stable.
•
- No communication between
electronic elements of the appliance.
Switch off and switch on again.
WARNING!
Deactivate the appliance
before you do the checks.
ENGLISH
25
Publicité
