Basic Controls; Setting The Clock; Safety Blocking - Bertazzoni So24Prox Guide De L'utilisateur

Basic controls

Setting the clock

After your microwave oven is first plugged in
or after a power failure, the clock display will
flash to indicate that the time shown is not
correct. To set the clock, proceed as follows:
1. Press the Clock key for 6 seconds (not
necessary on first plug-in or after a power
failure). The hour numbers will start to flash.
Displaying the Clock
To save energy, the clock is normally hidden.

Safety blocking

The oven functioning can be blocked (for
example, to stop it being used by children).
1. To block the oven, press the Stop key for 3
seconds. You will hear a sound signal and
the display will show the word "SAFE". The
2. Press key "-" and "+" to set the hours.
3. Press again the Clock key to set the
minutes. The minute numbers will start to
flash.
4. Press key "-" and "+" to set the minutes.
5. To finish, press the Clock key again.
If you want to see the clock, press the Clock
key briefly and the clock will be visible for 3
seconds.
SAFE
oven is blocked in this state and cannot be
used.
2. To unblock the oven, press the Stop
key again for 3 seconds. You will hear a
sound signal and the display will show
the time again.
12
USA
1,2 (>3s)