Bevel Gear; Maintenance Schedule - Husqvarna 324L Manuel D'utilisation

• Replace the spark plug if it is necessary.
To clean the air filter
CAUTION: An air filter that is damaged, very
dirty or soaked with fuel must always be
replaced.
An air filter that is used for a long time can not be fully
cleaned. Replace the air filter regularly and always
replace a defective air filter.
1. Move the choke lever up, to close the choke valve.
2. Remove the air filter cover and remove the air filter.
3. Clean the air filter with warm soap water.
4. Clean the inner surface of the air filter cover. Use air
or a brush.
5. Do a check of the surface of the rubber seal.
Replace the filter on the rubber seal if it is damaged.
6. Make sure that the filter is dry before you install it.
To apply oil to the air filter
CAUTION: Always use Husqvarna special
air-filter oil. Do not use other types of oil.
WARNING: Put on protective gloves. The
air-filter oil can cause skin irritation.
Maintenance
Clean the external surface.
1323 - 002 -
1. Put the air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally across
the air filter.
4. Push the unwanted oil out of the air filter while in the
plastic bag.

Bevel gear

The bevel gear is filled to ¾ with grease at the factory.
Before you use the product, make sure that the grease
level has not changed. Use Husqvarna special grease if
it is necessary to fill up. Do not replace the grease in the
bevel gear. Let servicing personnel do the repair of the
bevel gear.

Maintenance schedule

The following is a list of the maintenance steps that must
be performed on the product. Most of the items are
Maintenance on page 15
described in
Note: The user must only carry out the maintenance and
service work described in this operator's manual. More
extensive work must be carried out by an authorized
service workshop.
Daily Weekly Monthly
X
17