Setting The Temperature; Interior Light; Shelf Instructions - Danby DWC018A1BDB Guide D'utilisation Et D'entretien

Operating Instructions

SETTING THE TEMPERATURE

The temperature of the wine cooler is controlled by adjusting the thermostat control knob on the back
of the unit. To achieve maximum cooling temperature quickly:
• Turn the temperature control knob clockwise to the widest, darkest part of the graduated blue
control dial.
• Allow the unit to run at this setting for 3 - 4 hours.
• When maximum cooling is achieved, turn the temperature control knob to the middle position on
the graduated blue control dial, as per Fig. A.
• To turn the wine cooler off, turn the control knob to the "0" position, as per Fig. B. If the wine cooler
will not be used for an extended period of time, it is recommended to unplug the unit and leave the
door partially open to avoid possible formation of odors inside the unit.
Note: Wait 3 - 5 minutes before restarting the unit if operation has been interrupted.
Note: On the graduated blue dial, the thicker, darker blue indicates colder temperatures and the
thinner, lighter blue indicates warmer temperatures. The wine cooler temperature will vary depending
on the quantity of bottles stored in the unit and the frequency that the door is opened.

INTERIOR LIGHT

To manually operate the interior light, press the light switch situated on the right side of the interior
light housing on the ceiling of the unit. This will allow the light to remain on while the door is closed.
Note: The light will default to off. It can be turned on to run continually. Due to energy effi ciency
requirements for a wine cooler in this size, there is no option to have the light turn on when the door
opens.
DEFROST
This unit is equipped with an automatic defrost function and does not require manual defrosting.
Defrost water from the unit is channeled into a drip tray located above the compressor. Heat transfer
from the compressor causes the defrost water to evaporate.

SHELF INSTRUCTIONS

To remove a shelf from its locked position, lift the rear of the shelf
upward and then slide the shelf out of the unit.
To replace the shelf, ensure it is resting securely on the support
brackets and then push inward until the shelf locks into place.
6