Aurora AU-A1ZB320 Manuel D'installation

MODEL AU-A1ZB320
VOLTAGE (V) 220-240 V AC
LED DRIVER MAX LOAD 320 W PF ≥ 0.9
RESISTIVE MAX LOAD 320 W
INPUT CURRENT 1.1 A
OUTPUT VOLTAGE 220-240 V AC
AMBIENT TEMPERATURE LIMITS -20°C~50°C
IP RATING IP20
NUMBER OF OPERATING CYCLES 1E4
CIRCUIT DISCONNECTION Electronic Disconnection
PROTOCOL Zigbee HA1.2
CONDUCTOR TYPE & SIZE Twin and Earth 0.75~1.5 mm
Flat x2C+E 0.75~2.5 mm
FREQUENCY BAND 2400 MHz - 2483.5 MHz
MAX OUTPUT RF POWER 10 dBm/mW
INSULATING MATERIALS PTI 175
GLOW-WIRE TEMPERATURE 650°C
PROTECTIVE DEVICE 100°C Recoverable Temp control resistor
RATED IMPULSE WITHSTAND VOLTAGE 1.5 KV
USING THE APP TO CONNECT THE MODULE TO THE HUB
1. Follow instructions on the App to pair the Hub with the AONE
2. Put the module into pairing mode by:
a) Pressing the button for 3 seconds, or,
b) Powering the module off for 5 seconds and back on again 3 times
The module will flash twice to indicate it has entered pairing mode.
The module will flash a third time to indicate that it has successfully paired with
the HUB.
The module can then be controlled using the app.
• There are no restrictions of use.
• Installation must be carried out in accordance with the latest edition of the
Wiring Rules by a qualified electrician.
• Earth terminal is for Termination only.
• Hereby, Aurora Limited declares that the radio equipment type
AU-A1ZB320 is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
www.auroralighting.com/ProductDetail/AU-A1ZB320
Turn off the power
1
4
(UK)
2
2 (Australia)
7mm
CONDUCTOR TYPE TWIN AND EARTH 0.75~1.5 MM
& SIZE FLAT X2C+E 0.75~2.5 MM
6
8 Turn on the power
www.auroralighting.com
2 3
Cat. No. AU-A1ZB320
Input: 220-240V~, Max. 1.1A,
Output: 220-240VAC
Max Load: 320W 240V AC
Resistive Max Load: 320W
ta: -20°C~50°C tc: 75ºC
1.5KV Surge Protection
EN55015 / EN300 328
(UK)
2
Aurora LTD, 6 Little Burrow,
2 (AUSTRALIA) WGC, Herts, AL7 4SW. UK.
Made in PRC.
7
CEILING VOID REQUIREMENTS
Insert driver into the ceiling void and lay flat on the surface
L N N1 L1
EARTH
220-240V
50/60Hz
The product is Class II. However,
it is provided with a terminal
for earth continuity in case of
systems with earth conductor.
Cut-out diameter
Ceiling Void Depth
47mm
53mm
60mm
67mm
75mm
80mm
115mm
Document Version: AU-A1ZB320_V4_17
5
Standard
wiring
Loop in
loop out
wiring
Insert
55mm 65mm 68mm 72mm
X X X X
X X X X
X X X
X X X
X X
X