Cleaning; Care Of The Covers; Assembly Of New Cushion Plugs For The Cover Of The Bath Lift; Maintenance And Care - Drive DeVilbiss Healthcare BELLAVITA Mode D'emploi

If this reveals defects, wear or other damage which jeop-
ardize the safety of the lift, the bath lift must be taken
out of service and the deficiencies must be corrected.
Repairs must be performed by appropriate and suitably
qualified persons who can properly perform repairs of
this type based on their training, knowledge, and experi-
ence gained through practical work.
Have repairs performed only by the authorized dealer.
Attention: The manual control may be opened only by
the manufacturer of the bath lift!

Cleaning

The lift must be cleaned immediately after use (prefer-
ably by rinsing with hot water) in order to keep the bath
lift in optimum condition. For cleaning, the bath lift must
be thoroughly rinsed off after each bath. To clean the
bath lift (without covers), use household cleaners without
scouring agents, as well as commercially available disin-
fectants.

Care of the covers

The material of the removable covers is hygienic due to
the smooth surface and antibacterial properties.
Care of the covers requires regular cleaning either by
hand or in the washing machine at 60°C. Use a nonbi-
ological detergent without enzymes. Note that bath ad-
ditives containing oil which you use during bathing can
stain the cover. Failure to clean the covers regularly can
also cause the covers to discolor.
Note: Any discoloration of the covers is not covered by
the warranty since these are expendable parts.
• The covers can be easily removed for cleaning.
• Do not dry the covers in the dryer; instead they
should be hung to dry.
• In addition, it is recommended to use a com-
mercially available disinfectant.
• Follow the manufacturer's instructions!
Drive Medical GmbH & Co. KG | As per: 06.10.2020 | Errors and alterations excepted
Assembly of new cushion plugs for the
cover of the bath lift
First guide the new plug from above through the hole in
the cushion and then press on the underside of the disc
for reinforcement (photo 25 ­ 26).
25
26

Maintenance and care

Maintenance of the power supply unit
The power supply unit is maintenance-free. The hous-
ing should be cleaned only with solvent-free cleaners
or a slightly dampened cloth. In doing so, ensure that no
moisture penetrates the power supply unit. Before start-
ing up again, it must be ensured that the power supply
unit is completely dry. If necessary, the power supply unit
must be placed in a dry, ventilated location for several
hours without a power supply.
Attention:
For cleaning, the power supply unit must be complete­
ly separated from the mains by unplugging it from the
outlet.
Charging the battery
Charge the battery fully before each use. The voltage in-
formation on the power supply unit must be consistent
with the voltage of your power supply.
EN
25
Instructions for use BELLAVITA