Operation During Bathing - Drive DeVilbiss Healthcare BELLAVITA Mode D'emploi

RED light: Lift no longer ready to use, can still only move
upwards. Battery must be charged at once.
EMERGENCY STOP button (red):
If you are ever in an emergency situation in which it is
necessary to bring the bath lift to a stop, push the red
EMERGENCY STOP button (photo 19).
To reactivate the bath lift, press the green power button
once again. If no button is pushed, the manual control au-
tomatically switches off after 30 minutes. If you would like
to switch off the bath lift yourself, press the red button on
the manual control (indicator light goes out).
19

Operation during bathing

1. Before initial operation of the bath lift, ensure that
the manual control is correctly connected to the
bath lift via the plug connection. It is correctly con-
nected when the red ring on the jack is no longer
visible (photo 20).
20
2. Press the power button (green) on the manual con-
trol. Now the indicator light is lit and green.
3. Now press the up button (yellow). The backrest ini-
tially pivots into the upright position. Then the lift
moves up to the end position and automatically
switches off. If the button is released, the lift stops
so that intermediate positions are also possible.
Drive Medical GmbH & Co. KG | As per: 06.10.2020 | Errors and alterations excepted
• Down button (blue)
• EMERGENCY STOP
button (red)
• Indicator light (LED)
• Up button (yellow)
• Power button (green)
4. Swing out the side flaps until they rest on the edge
of the tub. Only raise the seat until the seat surface
is at the same height as the edge of the tub and the
side flaps form a horizontal surface.
Important: The side flaps must lie evenly on the edge of
the tub.
5. Seat the person to be bathed on the bath lift.
6. To lower the bath lift, press the down button (blue).
The lift first moves down to the end position. Then
the backrest automatically pivots backwards. In the
end position, the power unit switches off automati-
cally. If the button is released, the lift stops so that
intermediate positions are also possible.
Important! When the backrest touches the rear wall of
the tub, release the blue button immediately.
7. After the bath has ended, press the up button (yel-
low) on the manual control to bring the lift back to
the correct height (max. upper end point). Ensure
that the side flaps do not get caught on any exist­
ing tub grip handles.
8. Assist the person in getting out via the side of the
tub.
If the manual control is not used for 30 minutes, it auto-
matically switches off. If you would like to switch the bath
lift off yourself, press the red button on the manual con-
trol (indicator light goes out).
Note:
When raising and lowering the lift, lean against the
backrest and rest your hands in your lap.
If the lift remains in the tub, the manual control with
the integrated battery should now be unplugged and
charged. This prevents the battery from accidentally
draining.
EN
23
Instructions for use BELLAVITA