Putting On/Taking Off Covers; Mounting The Headrest (Optional); The Manual Control - Drive DeVilbiss Healthcare BELLAVITA Mode D'emploi

EN

Putting on/taking off covers

The covers can be easily put on and taken off.
To secure the cover, simply place the cover in the correct
position on the backrest plate or on the seat surface and
press the attachment buttons all the way into the respec-
tive holes of the backrest plate or seat surface and side
flaps (photo 12 ­ 15).
12
Seat cover
14
Seat cover
15
Backrest cover
The bath lift can also be used without a seat cover.
To remove the covers, pull the two attachment buttons
out of the holes from below using two fingers.
22
Drive Medical GmbH & Co. KG | As per: 06.10.2020 | Errors and alterations excepted
13
Backrest cover

Mounting the headrest (optional)

Insert both rods of the headrest into the openings on the
top of the drive unit. The desired height can be continu-
ously adjusted (photo 16 ­ 18 ).
16
18

The manual control

The capacity of the fully charged battery is sufficient for
a maximum of 6 baths, depending on the weight of the
user. During the bath, the indicator light on the manual
control is lit and green.
When the charge status of the battery falls to a certain
value, the color of the light changes to yellow and slowly
flashes. This now shows that approx. 1 more bath can be
taken. Thereafter the battery should be charged accord-
ing to the instructions.
If the yellow phase of the battery is also used, the color of
the light may change from yellow to red and flash quickly.
If this happens, the lift will only move upwards and thus
ensure safe lifting.
The battery must now be charged immediately according
to the instructions using the power supply unit provided.
GREEN light: Lift ready to use.
YELLOW light: Lift partially operational with enough
power for only 1 bath. Battery should be charged.
17
Instructions for use BELLAVITA