Optional Accessory - DeWalt D25872 Guide D'utilisation

English
SHOCKS Active Vibration Control®
System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool chip faster and active
vibration control will not engage.
D WALT Tool Tag Ready (Fig. A)
e

Optional Accessory

Your hammer comes with mounting holes
for installing a D WALT Tool Tag. You will need a T15 bit tip
e
to install the tag. Only use the screws provided. The D
Tool Tag is designed for tracking and locating professional
power tools, equipment, and machines using the D
Tool Connect™ app. For proper installation and use of the
D WALT Tool Tag refer to the D
e
Electronic Speed and Impact Control
(Fig. A)
The electronic speed and impact control allows the use of
smaller chisels without the risk of chisel breakage, chipping
into light and brittle materials without shattering and
optimal tool control for precise chiseling.
To set the speed dial 8 , turn the dial to the desired level.
The higher the number, the greater the speed and impact
energy. Dial settings make the tool extremely flexible and
adaptable for many different appli cations. The required
setting depends on the chisel size and hardness of material
being chipped.
Mode Selection (Fig. E)

WARNING: Do not select the operating mode when
the tool is running. Tool must come to a complete stop
before activating the mode selector button or damage
to the tool may result.
Your tool is equipped with a mode selector dial
select the mode appropriate to desired operation.
symbol Mode
Chisel
Adjustment
Chipping
To select a mode
• Rotate the mode selector dial
arrow points to the symbol corresponding for the
desired mode.
6
9 and fasteners
WALT
e
WALT
e
WALT Tool Tag manual.
e
to
4
Application
Chisel position
adjustment
Light chipping, chiseling
and demolition
4 so that the
Fig. E
nOTE: The arrow on the mode selector dial
pointing at a mode symbol at all times. There are no
operable positions in between.
Performing an Application (Fig. F)

WARNING: TO REDUCE THE RISK OF PERSONAL
INJURY, ALWAYS ensure workpiece is anchored or
clamped firmly.
nOTE: Operating temperature of this tool is 19 ˚ to 104 ˚F
(-7 ˚ to +40 ˚C). Using the tool outside of this temperature
range will decrease the life of the tool.
1. Insert the appropriate chisel and rotate it by hand to
lock it into the desired position. Refer to Chisel and
Chisel Holder.
2. Using the mode selector dial
Refer to Mode Selection.
3. Adjust the side handle 2
Fig. F
4
2
4. Place the chisel on the desired location.
5. Depress the rocker switch
6. To stop the hammer, release the switch.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
4
4 must be
4 , select chipping mode .
as necessary.
1
1 .