Mounting Instructions - Rointe T Série Manuel D'instructions

To select another day to be programmed, use
directly from day to day
the on/off button so that it stops flashing.
Repeat this until all the days you wish to be programmed have stopped flashing.
Once you are ready, we can move on to programming hour by hour by pressing the
NOTE: At this stage, it is possible that you have programmed the towel rails previously and
you are now changing the programming. When the days selected have different programming,
they will all change by default to the programming of the last day selected, which also happens
when programming with the remote control.
From the numbers we can see the selected hour in 24 hour display (0h is midnight, 01h, 02h,...).
On the hourly programming bar at the bottom of the screen you will see the programming
for the whole day and the selected hour flashing.
Use the button to change between COMFORT (
Move through the hours using
button every time you wish to change the setting.
If you do not wish to change the programming of a particular hour, continue to the next hour
you wish to change. Once all of the hours are programmed, or left blank without programming,
press the button to exit, or leave the unit for 30 seconds without pressing anything.

3. MOUNTING INSTRUCTIONS

Inside the box you will find a mounting kit.
1. Choose the right part of the wall.
2. Place the mounting stencil on the wall, marking the places for the holes.
3. Remove the stencil and make the holes in the wall.
4. Insert the rawl plugs in the holes made.
5. Screw the plastic fastener to the wall with the 6.3 x 50 mm screw.
6. Screw the two brackets for supporting the heated towel rail and the plastic fastener to the
horizontal tube of the heated towel rail like in Figure 1 with the 3/8" x 40 mm screw.
7. Insert what you have assembled in Section 6 into the plastic piece and fix well with the
2.9 x 9.5 mm stud bolt.
8. Place the cover on the piece supporting the heated towel rail.
6
6
8
7
5
Cross section of the towel rail
and day to day , if required) and select each day by pressing
symbol), ECO ( symbol) and OFF for every hour.
or and change each hour's programming using the
3
1
4 2
Figure.1.
and to change the day (we can move
1
10 mm Rawl Plug
2 Plastic Fastener
3 Screw 2.9 x 9.5 mm
4 Screw 6.3 x 50 mm
5 Plastic Fastener
6
Profile of Heated Towel Rail
7 Screw 3/8" x 40 mm
8 Cover
button.
9