Connecting Instructions; Important - Rointe T Série Manuel D'instructions

4. CONNECTING INSTRUCTIONS

Connection to the mains must be made observing the voltage stated on the product technical
data label.
This appliance is designed to be permanently installed connected to fixed facilities. The heated
towel rail power supply circuit must have an all-pole circuit breaker switch with a separation
of at least 3 mm between the contacts.
The appliance must be installed, if possible, away from any source of draughts (windows,
doors) or any other thing which may affect its functioning. In this way, the temperature will
not be affected. Place any object which might prevent the air flow (furniture, armchairs) 50
cm away from the front of the appliance.
The heater must never be installed immediately below a power point.
The lower part of the control panel must be placed at least 15 cm from the floor.
For any appliance, if the power cable is damaged, it must be replaced by a specific cable.
The replacement of the cable must be done by the maker, its after-sales service or qualified
personnel. The technical specifications of your appliance appear on the technical data label.

IMPORTANT

• This device must never be installed with its control panel at the top.
• This device must not be installed horizontally.
• During installation, use wedges so that the control panel will not be in contact with the floor.
OK
10