Assembly - Biesemeyer T-Square BC30 Manuel D'utilisation

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
CONSTRUCTING EXTENSION TABLE
ASSEMBLY (DELTA SAWS ONLY)
(FOR ALL OTHER SAWS, PROCEED DIRECTLY TO
PAGE 9, STEP 1.)
FRONT RAIL TO SAW
1. Assemble front rail (A) Fig. 5 to the front edge of the
saw table using the two 5/16-18 x 1-1/4" long flat
head Phillips screw, flat washer, 3/8" lock washer and
5/16-18" hex nut (B) supplied. Screws are inserted
throught the two larger countersunk holes in the front
rail and into the two holes in the front of the saw table
and fastened with the flat washer, lock washer and hex
nut. IMPORTANT: Do not tighten front rail mounting
hardware at this time.
FOR DELTA CONTRACTORS & HYBRID SAWS ONLY:
Hang the on/off switch from the front rail mounting bolt on
the left side of the saw, as shown in Fig. 6, before putting
on the flat washer, lock washer and hex nut.
2. Using template (C) Figs. 5 & 7, Check and adjust the
front rail on both sides of the saw blade as shown, to
make sure the rail is parallel with the table surface. The
horizontal portion of the rail should be down from the
top of the table surface 2-27/32". Tighten the front
rail mounting hardware when you are certain the
rail is set at the proper depth.

ASSEMBLY

FIG. 4
C
A
6
B
FIG. 5
FIG. 6