Publicité
Les langues disponibles
Les langues disponibles
Laser Continuous
Press and hold down the key when switching on the device until the cha-
racter
appears permanently in the display with beep sounds. Every further
press of the
key releases a distance measurement.
and hold to switch the device and laser continuous operation off.
Illuminating display
button (press short), the illuminating display can be turned on or off.
Operation
Switching on and off
Switches
on the instrument and laser. The display shows the battery
symbol.
Pressing this button longer to switch off the instrument.
The instrument switches off automatically after three minutes of inactivity
Clear button
The last action is canceled. While making area or volume measure-
ments, each single measurement can be deleted and remeasured in series.
Reference setting
The default reference setting is from the rear of the instrument. The display
will show you
.
Press long this button to take the next measurement
from the front edge. The display will show you
the rear reference is set again.
Measuring
Single distance measurement
Press to activate the laser. Press again to trigger the distance measure-
ment. The result is displayed immediately.
20
Press the key
.
Press this button,
Minimum / maximum measurement
This function allows the user to measure the minimum or maximum distance
from a fixed measuring point. It can also be used as to determine spacing. It is
commonly used to measure room diagonals (maximum values) or horizontal
distances (minimum values) or the difference of maximum and minimum.
Press and hold down this button until you hear a beep. Then slowly
sweep the laser back and forth and up and down over the desired target point
(e.g. into the corner of a room).
Press to stop continuous measurement. The values for maximum and
minimum distances are shown in the display as well as the last measured
value in the summary line.
Functions
Addition / subtraction Distance measuring.
Press this button once.The next measurement is added to the previous one.
Press this button again. The next measurement is subtracted from the
previous one. This process can be repeated as required. The measurement
will be displayed in the summary line while the previous one displayed in the
secondary line.
The last step is will be reverted. This function is also available for area
and volume measurement..
Area
Press once. The symbol
Press this button to take the first length measurement (e.g.length).
Press it again to take the second length measurement (e.g.width). The
result is displayed in the summary line.
appears in the display.
21
Publicité
