Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
Read this manual carefully before using the
machine, for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe the
enclosed safety instructions as well as the additional
safety instructions.
The following symbols are used throughout this
manual:
Denotes risk of personal
injury or damage to the tool.
ADDITIONAL SAFETY INSTRUCTIONS FOR
CIRCULAR SAWS
M ake sure that all devices screening the
saw blade are in perfect working order.
M ake sure that the saw blade is screened
correctly. Especially observe the following
instructions:
- Never block the saw blade guard.
Repair a jammed saw blade guard
before using the machine again.
- Replace a broken tension spring before
using the machine again.
- Never remove the riving knife.
The distance between the toothed rim
and the riving knife should be 5 mm maximum.
The height difference between the riving
knife and the toothed rim should be 5 mm
maximum.
D o not use saw blades made of HSS steel.
D o not use bent, deformed or otherwise
damaged saw blades.
D o not use saw blades which do not meet
the specifications stated in this manual.
B efore sawing, remove all nails and other
metal objects from the workpiece.
N ever start sawing before the saw reaches
its full speed.
S ecurely clamp the workpiece. Never
attempt to saw extremely small workpieces.
O nly put the machine aside after switching
off and when the saw blade has come to a
complete standstill.
N ever try to slow the saw blade down by
exerting pressure on the side.
B efore performing maintenance to the
machine, always unplug the machine.
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
GB CIRCULAR SAW
DESCRIPTION
Your circular saw has been designed for
sawing wooden workpieces. The machine is
only suitable for right-hand use. The machine
is not suitable for stationary use.
1 On/off switch
2 Lock-off button
3 Dust extraction connector
4 Scale for saw blade depth
5 Adjusting screw for depth of cut
6 Ventilation opening
7 Guide handle
8 Scale for mitre angle
9 Adjusting screw for mitre angle
10 Shoe
11 Marking for bevel cuts
12 Marking for straight cuts
13 Parallel fence
14 Adjusting screw for parallel fence
REPLACING THE SAW BLADE
Only use sharp and undamaged saw blades.
Cracked or bent saw blades must be replaced
immediately.
screw (17) and remove it.
position shown in the illustration.
new saw blade (16) with the teeth pointing in the
direction of rotation.
See the arrow on the housing.
normal position.
secure the fixing screw.
H old the flange (18) using the spanner 20).
U se the spanner (21) to loosen the fixing
R emove the flange (18).
H old the saw blade guard (15) in the
R emove the old saw blade and place the
M ove the saw blade guard back into its
P lace the flange on the saw blade and
A djust the riving knife (19).
Before replacing the saw
blade always unplug the tool.
Never use saw blades with a
thickness exceeding the
thickness of the riving knife
or saw blades with a tooth
setting smaller than
the thickness of the riving
Do not use saw blades made
of HSS steel. Make sure that
the spindle diameter
corresponds to the bore
knife.
diameter.
Publicité
Table des Matières
