SonicWALL SonicWave 432o Guide De Démarrage page 3

NOTE: Use anchors when mounting to cement walls. Mounting screws are not included.
Mounting the SonicWave 432o on a Pole
IMPORTANT: This device must be professionally installed using either the supplied antennas or with
approved alternate antennas available from SonicWall.
To mount the SonicWave 432o unit on a pole:
1. Fasten the wall‐mount base securely to the back of the SonicWave 432o using the provided mounting screws.
2. Attach the pole‐mount bracket to the wall‐mount base using with the provided screws. The pole‐mount bracket
can be attached either vertically or at a tilt of up to 30 degrees, depending on your requirements.
3. Loop the provided pole strap through the slots on the pole‐mount bracket and then around the pole.
4. Tighten the strap with an appropriate screw driver and ensure that the device is firmly in place.
Installing SonicWave 432o Antennas
Install the external antennas (or approved alternates) intended for area coverage. The SonicWave 432o features
dual concurrent radio signals. Use the 2.4 GHz antennas to access Radio 1 (802.11 b/g/n at 600 Mbps) signals, and
the 5 GHz antennas to access Radio 2 (802.11 a/n/ac at 1733 Mbps) signals. You should use all eight WiFi antennas
to utilize both radio frequencies concurrently.
CAUTION:
RF output ports connected to an antenna.
To install the antennas on your SonicWave 432o:
Remove all eight antennas from their bags and place one on each of the appropriate connectors,
1.
matching the radio signals marked on the antennas to those marked above the connectors
2. Insert the antenna base firmly into the antenna mount.
3. Carefully finger‐tighten the fittings being cautious not to over‐tighten them.
4. Repeat with the remaining antennas.
To prevent damage to the SonicWave, do not enable the radios without all
Safety and Regulatory Information
3