Télécharger Imprimer la page

SonicWALL SonicWave 432o Guide De Démarrage page 2

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
WARNING:
Electrical Hazard: Only qualified personnel should perform installation procedures. Within the
context of the safety notes in this documentation qualified persons are defined as persons who are
authorized to commission, ground and label devices, systems, and circuits in accordance with established
safety practices and standards. A qualified person understands the requirements and risks involved with
installing outdoor electrical equipment in accordance with national codes.
Restricted Access location. This product is not intended to be installed and used in a home or public area
accessible to the general population.
Ground Connection
The ground connection for the SonicWave 432o is located on the back of the device. Attach the green ground to
earth cable to the grounding terminal.
1
Use the ground screw assembly, with the star washer, to attach the ground wire's ring terminal to the
SonicWave. The wire should be as close to the SonicWave bottom as possible.
2
Tighten the screw securely.
Mounting the SonicWave 432o Appliance
IMPORTANT:
This device must be professionally installed.
Attach the SonicWave 432o to a surface that can support it and withstand its environment. It can be mounted to a
wall, girder, or pole, and the surface material can be concrete, brick, wood, metal, or plastic.
Mount the SonicWave so that the input and output ports are on the right side of the SonicWave. You should provide
a threeinch drip loop on all cables.
To mount the SonicWave 432o on a wall:
1
Using the wall‐mount base as a guide, mark the location of the mounting screws on the wall surface.
2
Using a drill, drill four mounting holes into the wall as follows:
for installing the SonicWave on a masonry wall, use a 5/16" diameter bit.
for other materials, use the appropriate drill for the screws being used.
3
For masonry installations, place four anchor assemblies into the holes.
Attaching the Mounting Bracket to the SonicWave
Attach the mounting bracket to the back of the SonicWave 432o using four M4 screws, four spring washers, and
four flat washers:
1
Attach the SonicWave 432o and base assembly to the wall using the provided mounting bolts.
2
Finger tighten the mounting screws securely, but do not apply more torque than is necessary.
3
Secure the anchors to the wall, and then secure the bracket to the anchors.
Safety and Regulatory Information
2

Publicité

loading