Renkforce 2522779 Mode D'emploi page 20

• When installing and operating the system, always observe the applicable motor
vehicle regulations and road traffic regulations.
• Prior to all installation work, always disconnect the minus pole of the battery. This
prevents the danger of short circuits. Only connect the negative pole of the battery,
when you have completely connected the system and checked the connections.
Observe the notices of the vehicle manufacturer in order not to lose vehicle-
specific data memory.
• Only use a volt meter or a diode test lamp for checking the voltage on the vehicle
system leads, as normal test lamps consume excessive voltage and may thus
damage the vehicle's electronics.
• When installing cables make sure that the connection cables are not squeezed or
damaged by sharp edges. Use rubber bushings for passing points.
• Modifications to the vehicle which are made necessary through the installation of
the parking aid must always be carried out in such a manner that neither the traffic
safety nor the designed stability of the car is impaired.
• If you are in doubt about where to install the device, consult your car dealer.
• Before drilling the attachment holes make sure that the electric cables, brake
lines, the fuel tank or similar systems will not be damaged.
• When using tools to install your parking aid, observe the manufacturers' safety
precautions.
• When installing components, take into consideration the risk of accident which
can arise from parts being torn away in case of an accident. Therefore you should
securely fasten every part in a place where it cannot become dangerous for the
passengers of the car.
• Consult an expert when in doubt about the operation, safety or connection of
the device.
• Maintenance, modifications and repairs must only be completed by a technician
or an authorised repair centre.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) Connected devices
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
20