Télécharger Imprimer la page

AEG SB7300S Mode D'emploi page 20

Publicité

Cleaning and care
1. Quick cleaning: Pour warm water
GB
into the jug, add a few drops of
detergent. Mix water and detergent
by pressing the "PULSE" button.
Finally, rinse the jug under running
water.
Troubleshooting
Troubleshooting
Symptom
The blender does not
switch on.
20
2. Thorough cleaning: Turn the
blender off and unplug the power
cord. Wipe the motor housing with
a damp cloth.
Warning! Never immerse the
housing, plug, and cord in water or
any other fluid.
Cause
Components are not fixed properly.
The On/Off button is not pressed.
The jug is overfilled.
The plug is not properly connected to the
power outlet.
Power outage.
Functional problem.
3. Remove the lid and jug. Turn the
blade assembly clockwise and
remove it. Turn locking collar clock-
wise to unlock. Lift of the locking
collar, the blade assembly and
the rubber seal. Rinse the blade
assembly in water and detergent.
Caution! Handle carefully, the
blades are very sharp! The lid, jug
and measuring cup can be washed
in the dishwasher.
Solution
Check if all the components are properly
locked into position.
Make sure the On/Off button is illuminated.
If not, press the On/Off button to turn the
blender on.
Empty the jug so you do not exceed the
maximum level.
Check the connection of the plug to the out-
let or try another outlet.
Wait until power outage is over.
Contact authorized service.

Publicité

loading

Ce manuel est également adapté pour:

7 serie