Operating Procedures - Airco BN5018A Guide D'utilisation

IMPORTANT SAFETY INSTRUCTIONS
unwanted fastener will be fired.
19 DO NOT DRIVE FASTENERS on top of other fasteners, or with the tool
at too steep an angle: the fasteners can ricochet causing personal injury.
20 DO NOT DRIVE FASTENERS too close to the edge of the workpiece.
The workpiece is likely to split, allowing the fasteners to fly free or
ricochet causing personal injury.
21 STAY ALERT. Keep hands and body away from the path of any potential
fired fastener. Watch what you are doing & use common sense. Don't
operate any tool when you are tired.
22 GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with
grounded surfaces: pipes, radiators, ranges, and refrigerator enclosures.
Before driving fasteners into walls, floors, or wherever "live" electrical
wires may be encountered, try to ascertain whether there is a danger of
shock.
23 KEEP WORK AREA CLEAR of obstructions.
24 EMPLOYERS must enforce compliance with the safety warnings and
all other instructions in this manual. Keep it available for use by everyone
assigned to use this tool.
.
BN5018A SPECIFICATIONS
Shoots industry standard 18 gauge brad nails in the following sizes: 15mm (5/
8"), 20mm (3/4"), 25mm (1"), 30mm (1-3/16"), 35mm (1-3/8"), 40mm (1-9/16"),
45mm (1-3/4") and 50mm (2")
Operating pressure (min. to max.): 60-100 psi / 413 to 690 kPa / 4.13 to 6.9 bar
Air consumption: 2-4 cfm / 57-113 litres per min.@ 60-90 psi / 414-621 kPa
Air inlet: ¼"NPT
Padded hand grip.
Tool weight: 3.3 lb / 1.5 kg
Pkg. weight: 4.0 lb /1.8 kg

OPERATING PROCEDURES

UNPACKING THE TOOL
Check and make sure one of each of the following are all included.
BN5018A Combination Nailer Stapler
S3 hex key
S4 hex key
Small bottle of air tool oil
Operating instructions
SETUP: AIR SOURCE
· The BN5018A is designed to operate on clean, dry, compressed air,
regulated at 60-100 psi / 413 to 690 kPa / 4.13 to 6.9 bar. The preferred system
would include a filter, a pressure regulator, and an automatic oiler located as close
to the tool as possible (within 15 feet / 5 meters is ideal). Do not use bottled air or
gases.
· All compressed air contains moisture and other contaminants that can
harm the internal components of the tool. An air line filter will remove most of
these and significantly prolong the life of the tool. Ensure the in-line oiler has
sufficient oil. If an in-line oiler is not available, place 2 drops of oil into the tool's air
inlet at the beginning of each workday. More than this will be expelled from the
tool's exhaust during firing.
3