Using The Device; Care And Maintenance - Elcoman KOBRA FLEXPACK PRO Mode D'emploi

Shred

USING THE DEVICE

TAV. B and TAV. C, Page 14
When the device has been connected to the mains, switch the main button I/0 (8 - Tav. C) placed
on the back of the machine. Kobra symbol (5 - Tav. B) placed in the middle of the control panel will
turn on for about 10 seconds and then, it will turn off leaving on the stand-by LED (6 - Tav. B). Kobra
FlexPack is now in stand-by mode.
Press the FORWARD button (1 - Tav. B) on the control panel to start the cutting knives.
When shredding is finished, press STOP (2 - Tav. B) on the control panel to stop the cutting knives
and halt the machine.
CARDBOARD FEEDING
TAV. D and TAV. E, Page 15
The cardboard is processed for a maximum
width of 427 mm. If the cardboard is larger than
427 mm, the machine will automatically cut the
excessive part of the cardboard.
By adjusting the working width scale (1 - Tav. D),
it is possible to adjust the processing working
width of the cardboard according to the user
needs.
By means of a specifically designed tension
system (2 - Tav. E) placed at the exit of the
processed material on the back of the machine,
TAV. D
16
KOBRA FLEXPACK PRO
it is possible to adjust the compression volume
of stiff cardboard:
- Unscrew the flap setting knob (3 - Tav. E)
- Adjust the flap (2 - Tav. E) turning it towards
the exit of the material in order to have the
cardboard exiting against the flap. By doing
so, the cardboard will soften and will become
more flexible.
The flap (2 - Tav. E) can be left completely open
to process standard cardboards.
TAV. E
WARNING!
When using the machine, avoid continuous forward and reverse operations as this could cause
jammings, blocking the exit of the processed cardboard material that will only get freed by a
manual extraction of the cardboard.

CARE AND MAINTENANCE

TAV. F and TAV. G
Before doing any maintanance or repairs or
touching the internal parts of the machine,
unplug the cable from the power supply.
Kobra FlexPack is equipped with an hour meter
(1) that enables the user to check the amount of
hours of operation in order to decide possible
care and maintanance operations.
After 100 hours of continuous operation it is
suggested to clean the inside of the machine as
shown in Tav. G:
TAV. F
KOBRA FLEXPACK PRO
Shred
- Unscrew the screws (2)
- Remove panels (3)
- Unscrew the screws (4)
- Remove panel (5)
Manually remove the accumulated dirt within
the machine and under the kitting knives.
WARNING! Do not use synthetic oil to clean
the machine, nor abrasive products, detergents,
petroleum or solvents.
TAV. G
17