KOBE CHX30 Série Manuel D'installation Et Mode D'emploi page 8

Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT
ENTERING THE VENT OPENING.
•
Decide the location of the venting pipe
from the hood to the outside. Refer to
Figure 1.
•
A straight, short venting run will allow
the hood to perform more efficiently.
•
Try to avoid as many transitions,
elbows, and long run as possible. This
may reduce the performance of the
hood.
•
Temporarily wire the hood to test for
proper operation before installing.
•
Important: Peel protective film off
the hood (if any).
•
For installing under the cabinet with
recessed bottom, attach 4-inch wide
wood filler strips (not included) on each
side. Refer to Figure 2.
•
Using reference on Page 13 and 14 to
measure and create access opening for
electrical wires and exhaust under the
cabinet {refer to Vent Option Installation
on 7}. Refer to Figure 3.
•
Using reference on Page 13 and 14 to
position the mounting
included) underneath the cabinet. Refer
to Figure 4.
Install Lights before mounting hood
To install the light fixture:
-
Insert the light fixture into the socket
and turn it clockwise to secure the
light fixture.
DEBRIS FROM
screws (not
www.goedekers.com
Figure 1
Figure 2
Figure 3
Figure 4
6